1. Fittings are note recommend for use with liquids other than water and food or beverage products, where fittings maybe used with other chemicals contact with us for advice.
2. Do not disassemble or modify the individual product, as this may cause a product malfunction, leak or failure.
3. Do not over-stress the fitting by rotation, twist,bending,shock,fatigue,or other excess force this is may damage the fitting and cause malfunction,leak,or failure and voids.
4. Do not use the product where ambient temperature or fluid temperature may exceed 45℃ in domestic environment food & Drink,industrial pneumatic.this may damage the fitting and cause malfunction,leak or failure.
5. Do not use pipe dope or other liquid thread sealers. Use only teflon tape to seal threaded connections.
6. We reserves the right to modify the product form time to time as required for quality improvement and per market requirement. actual product may differ form pictures shown.
7. Before making any tube connection, verify that the end of the tube has been cut squarely and there are no scratches on the tube O.D within 30mm of the end.
8. When making a tube connection,occasionally a gripping of the tube may occur just as the tube begins to pass through the O'ring,although the seal is not yet made. In this case, push the tube deeply once more to complete assembly of the connection.pull it once,after pulling, Failure to completely seat the tube into the fitting may cause a leak.
9. When using metallic or stiff tubing(such as a solenoid valve, filter plug),de-burr the tube ends to avoid potential cutting or other damage to the O'ring.
10. When disassembling tube connections, always press the collet evenly toward the body and then pull the tube. If a locking is used, remove the locking clip before attempting to separate a tube connection.
11. When tightening threaded fittings, use care not to over-torque the fitting as this may damage the fitting and cause a leak or other failure.